Skip to content
EMV Tools

Tools

TTQ decoder (9F66)

The Terminal Transaction Qualifiers (TTQ, tag 9F66) are four bytes a contactless reader sends to the card in the PDOL data of GET PROCESSING OPTIONS. They say what the reader supports and what it requires for this transaction.

Look at it when a contactless card takes an unexpected path, such as asking for a PIN or going online, because the card reads these bits before it decides.

Byte 1 lists the supported modes and cardholder verification methods (CVM), byte 2 says whether this transaction needs an online cryptogram or a CVM, and byte 3 covers issuer updates and consumer device verification (CDCVM).

Worked example: 36 00 40 00 says the reader supports EMV mode (qVSDC), the contact chip, online PIN, and signature, and supports CDCVM.

New to EMV? Read EMV in 5 minutes or browse the glossary

Everything runs in your browser. Nothing you enter leaves this page.

Spaces, line breaks, colons, and the 0x prefix are ignored. Toggle the bits to build a value; the hex updates as you go.

Hex value: 00000000

How to read it: bytes are numbered from 1 on the left, and bits from 8 (the leftmost) to 1 (the rightmost). A set bit is 1. Bits reserved for future use (RFU) should be 0.

Byte 1: 00
BitStateMeaning
b8
b7
b6
b5
b4
b3
b2
b1
Byte 2: 00
BitStateMeaning
b8
b7
b6
b5
b4
b3
b2
b1
Byte 3: 00
BitStateMeaning
b8
b7
b6
b5
b4
b3
b2
b1
Byte 4: 00
BitStateMeaning
b8
b7
b6
b5
b4
b3
b2
b1

How bits are numbered

How bits are numberedA value of 4 bytes. Bytes are counted from the left, starting at byte 1. Inside each byte, bits go from b8 on the left to b1 on the right: b8 is the most significant bit, worth 80 in hex, and b1 is the least significant, worth 01.Hexb880b740b620b510b408b304b202b101Byte 1Byte 2Byte 3Byte 4
A value of 4 bytes. Bytes are counted from the left, starting at byte 1. Inside each byte, bits go from b8 on the left to b1 on the right: b8 is the most significant bit, worth 80 in hex, and b1 is the least significant, worth 01.