Terminal capabilities decoder (9F33)
Terminal Capabilities (tag 9F33) are three bytes that describe the terminal: how it reads cards, which cardholder verification methods it supports, and which security functions it runs. They come from the terminal configuration, and the terminal sends them in DE 55.
Look at it with the AIP (82) and the CVM List (8E) when the terminal skips offline data authentication or picks an unexpected verification method, or when you configure a terminal profile.
Byte 1 lists card input methods, byte 2 cardholder verification methods, and byte 3 security functions. Each set bit is something the terminal can do. Use the builder to set a value for a terminal profile.
Worked example: E0 F8 C8 from the terminal data example is a terminal that reads cards by manual key entry, magnetic stripe, and contact chip; supports plaintext and enciphered offline PIN, enciphered online PIN, signature, and no CVM; and supports SDA, DDA, and CDA.
New to EMV? Read EMV in 5 minutes or browse the glossary
Everything runs in your browser. Nothing you enter leaves this page.
Spaces, line breaks, colons, and the 0x prefix are ignored. Toggle the bits to build a value; the hex updates as you go.
Hex value: 000000
How to read it: bytes are numbered from 1 on the left, and bits from 8 (the leftmost) to 1 (the rightmost). A set bit is 1. Bits reserved for future use (RFU) should be 0.
| Bit | State | Meaning |
|---|---|---|
| b8 | ||
| b7 | ||
| b6 | ||
| b5 | ||
| b4 | ||
| b3 | ||
| b2 | ||
| b1 |
| Bit | State | Meaning |
|---|---|---|
| b8 | ||
| b7 | ||
| b6 | ||
| b5 | ||
| b4 | ||
| b3 | ||
| b2 | ||
| b1 |
| Bit | State | Meaning |
|---|---|---|
| b8 | ||
| b7 | ||
| b6 | ||
| b5 | ||
| b4 | ||
| b3 | ||
| b2 | ||
| b1 |